在用大幅面纤维水泥板做内外墙板、吊顶板时，主要配以轻钢龙骨、木龙骨骨架等，由于该板板面平整、光洁，故严格要求龙骨骨架安装平整稳固

When making the inner and outer wall panels and ceiling boards with large format fiber cement boards, the light steel keel and wooden keel skeleton are mainly used. Because the plank surface is smooth and clean, the keel skeleton is strictly installed and smoothed.

大幅面纤维水泥加压板固定在龙骨上，其龙骨间距一般为600mm，当墙体高度超过4m时，按设计计算确定。

The large surface fiber cement compression plate is fixed on the keel, and the length of the keel is generally 600mm. When the height of the wall is more than 4m, it is determined according to the design calculation.

用自攻螺丝钉固定大幅面纤维水泥板，其钉距：吊顶板为150-200mm，墙板一般为200-300mm，钉孔中心与板边缘距离：吊顶板10-15mm，墙板10-15mm。

The large fiber cement board is fixed by self tapping screws. The nail spacing is: the ceiling plate is 150-200mm, the wallboard is generally 200-300mm, the distance between the center of the nail hole and the edge of the plate is: the ceiling plate 10-15mm and the wall panel 10-15mm.

使用螺钉的规格应根据选用龙骨的纤维水泥板种类、规格决定，并根据选用大幅面纤维水泥板的厚度，由设计人员确定螺钉的直径与长度。

The specifications of the screw should be decided according to the type and specification of the fiberboard used for keel, and the diameter and length of the screw can be determined by the designer according to the thickness of the large fiber cement board.

在将大幅面纤维水泥板与龙骨固定时，手电钻的钻头直径应选用比自攻螺钉直径小0.5-1mm的钻头打孔，固定后钉头处要及时途上底漆或腻子。防止钉头在喷涂或贴装饰材料前生锈而影响面层美观。

When the large format fiber cement board and keel are fixed, drill bit diameter should be punched with 0.5-1mm smaller than the diameter of the self tapping screw. After fixing, the nail head should be primed or putty on time. Prevent the nail head from painting or sticking the decorative material before rust and affect the appearance of the surface layer.